Bosch 980cc Motorsport Injector (EV14)
Name: Bosch 980cc
Part number: 0280158040 / 0280 158 040 / Bosch -040
Package: 1x
Connector: Bosch JPT EV1 Minitimer Jetronic
Length: 33,6mm - EV 14C (Compact) Use top and bottom adapter to get 60,65mm EV 14L (Long) (adapters not included)
Injector tip: xT 24mm
O-ring top: 14mm Viton
O-ring bottom: 14mm Viton
Body diameter: 16mm
Impedance: 12 ohm
Spray pattern: 30 degrees Conical
Spray angle: Neutral (0 degrees)
Flow: 670g / 980cc / 980cm3 @ 3 bar
Fuel: E85 / M100 compatible and can handle other standard fuels due to the stainless internal parts. ATTENTION! If the injector is to be run on methanol, it must be run through with regular fuel after use. These injectors must not be in contact with methanol over more extended periods.
Max flow measured static in test environment
29 PSI (2 bar) 720cc / min = 69 lb / h
43,5 PSI (3 bar) 900cc / min = 86 lb / h
58 PSI (4 bar) 1038cc / min = 99 lb / h
78,5 PSI (5 bar) 1170cc / min = 111 lb / h
88 PSI (6 bar) 1284cc / min = 122 Ib / h
101,5PSI (7bar) 1344cc / min = 128 lb / h
Please note that test environment versus practical use can vary widely depending on peripheral equipment and other technical factors. However, this is excellent information on what to expect from the injectors and essential information when choosing other components in the fuel system, such as fuel pump, fuel pressure regulator, and fuel filter.
Engine power Turbo
Petrol 10% margin
1cyl - 129hp (129x1)
4cyl - 516hp (129x4)
5cyl - 645hp (129x5)
6cyl - 774hp (129x6)
8cyl - 1032hp (129x8)
Ethanol 10% margin
1cyl - 112hp (112x1)
4cyl - 448hp (112x4)
5cyl - 560hp (112x5)
6cyl - 672hp (112x6)
8cyl - 896hp (112x8)
Engine power N/A
Petrol 10% margin
1cyl - 168hp (168x1)
4cyl - 672hp (168x4)
5cyl - 840hp (168x5)
6cyl - 1008hp (168x6)
8cyl - 1344hp (168x8)
Ethanol 10% margin
1cyl - 140hp (140x1)
4cyl - 560hp (140x4)
5cyl - 700hp (140x5)
6cyl - 840hp (140x6)
8cyl - 1120hp (140x8)
Flow matching
These injectors are shipped with factory tolerances unless you choose to have them flow-matched. We always recommend flow-matching before delivery. Factory tolerances of the injectors differ, and you have to run them unmatched with wider tolerances or compensate for this when tuning the engine management system. How much they differ from the factory continuously varies.
Flow-matching is done with our top equipment when you add this option! In addition, we include documentation and certificates with your new injectors.
----------------
Guides & Info
Jag köpte dessa spridare ihop med adaptrar för att få standardmåtten ~60mm.
Det har fungerat bra både med montering och tekniskt sedan dess.
Your review:
To send a review, you must be logged in.
Associated products
